Drivers and controllers for electromotors

 
call:
+ 372 6559914
send e-mail:

BMS7152-50 - complete DC worm gear drive with RS-485

BMS7152-50 is a complete set, included DC motor controller BMSD and a DC brush gearmotor SM7152W with worm gearhead 1/50. The drive is reversible, gearhead is self-impeding. Two side output shaft is turned through an angle of 90° relative to the motor shaft. Motion control via RS-485 is provided.

The BMSD controller, included to the complete drive, adjust motion speed, direction, acceleration and deceleration. The motion control provided by input signals or by commands via RS-485 interface.

Motor speed is adjusted by analog voltage signal 0-5VDC, by potentiometer - internal (there is a built-in potentiometer on the case of the BMSD controller) or external (can be connected to the controller) or by a command via RS-485. Start/stop and direction are digital signals, also can be controlled via RS-485. The inputs are duplicated by buttons on the controller's case. Inputs (and buttons) handle a signals as per the front edge or signal level. The version depends on a controller firmware - please, ask when order.

The main parameters of DC brush geardrive BMS7152-50

  • Motor power: 150W
  • Rated torque: 104.5kgf*cm
  • Rated speed: 50rpm
  • Reduction ratio: 1/50
  • Gearhead type: worm
  • Voltage: 24VDC
  • Current: <6.5Amp
  • Dimensions of gearmotor SM7152W

    Dimensions of gearmotor SM7152W

    Dimensions of DC brush motor controller BMSD

    Dimensions of  DC brush motor controller BMSD
    BMS7152-50 -  complete DC motor drive with worm gearhead with RS-485
    QUICK MESSAGE



    Smart Motor Devices OÜ: Tallinn Science Park Tehnopol
    Mäealuse st. 4, Tallinn 12618, Estonia
    Copyright © 2010-2017 SmartMotorDevices OÜ