Products

We design and manufacture high-quality and cost effective drivers and controllers for DC brush, BLDC and stepper motors

Catalog products

Breadcrumps

  • WEDL

    Optical encoder

    The WEDL encoders have a 5 V TTL signal (A and B) as well as the index signal I. They are optionally available with line drivers which, in addition to positive signals, also provide inverted signals, thus increasing the interference immunity at distances of more than 50 cm. Maximum motor speed is 6000 rpm or 12000 rpm depending on resolution.

    Optical encoder

    Operation voltage 5 VDC
    Encoder resolution 500 CPR or 1000 CPR
    Shaft diameter 5 mm or 6.35 mm
    Encoder signal incremental
      A, A\, B, B\, I, I\
    Related product ZK-WEDL - Encoder cable
  • WEDS

    Optical encoder

    Optical encoders are used for the precise speed and position monitoring of moving loads. They are suitable for a wide range of applications, insensitive to dust and dirt, and can be easily integrated into customized systems. They offer high resolutions and low tolerances. Maximum motor speed is 6000 rpm or 12000 rpm depending on resolution.

    Optical encoder

    Operation voltage 5 VDC
    Encoder resolution 500 CPR or 1000 CPR
    Shaft diameter 5 mm or 6.35 mm
    Encoder signal incremental
      A, B, I
    Related product ZK-WEDS – Encoder cable
  • SMSD-4.2CAN

    NME1

    Magnetic encoder

    Encoder for stepper and BLDC motors with 1024 pulses per revolution is used for precise speed and position control. Magnetic encoders enable precise measurements even in harsh environmental conditions. Hall sensors are used for scanning, the values are supplied in the form of a binary signal.

    Magnetic encoder

    Operation voltage 5 VDC
    Encoder resolution 1024 CPR
    Shaft diameter 5 mm or 6.35 mm
    Encoder signal incremental
      A, A\, B, B\, I, I\, H1, H2, H3
    Related product ZK-NME1 – Encoder cable
  • NOE2

    Reflective encoder

    Optical 3-channel reflective encoder can also be combined with very small BLDC and stepper motors thanks to their compact dimensions. Due to the integrated line driver, they are insensitive to electrical interference even with long connection cables, and achieve high signal quality.

    Reflective encoder

    Operation voltage 5 VDC
    Encoder resolution 1000 CPR
    Shaft diameter 5 mm or 6.35 mm
    Encoder signal incremental
      A, A\, B, B\, I, I\
    Related product ZK-NOE – Encoder cable